Digital Security Controls PC1575 Manual de instalación descargar pdf (Pagina 91)

Set 24-hour Clock

The panel’s 24-hour clock can be set using the computer’s internal clock. When this

selection is made, you will be prompted as to whether or not you wish to use a time

offset. The time offset feature is useful when communicating with a panel in a different

time zone. If you select the time offset function, you will be asked to enter the hour

offset. The allowable offset range is from -9 to +9 hours. It is not necessary to enter

the + character to indicate a positive offset.

Quick Arm Status

This feature allows the user to remotely enable or disable the quick arm feature.

When selected, a second menu appears. Press the space bar to toggle disable/

enable then [ENTER] to enter your selection to the Batch File. For the PC1150, refer

to Programming Section [31] Zone Light 5.

Auto-Arm Status

This feature is similar to the Quick Arm feature. Toggle this feature to disable/enable

it then press [ENTER] to add to the Batch File.

Door Chime Status

Toggle the desired door chime function, then press [ENTER].

Terminate Call / Hang Up

THIS FUNCTION MUST BE ADDED AT THE END OF ALL BATCH FILES AND MUST NOT

APPEAR MORE THAN ONCE IN ANY BATCH FILE. It is used to disconnect the panel

from the computer. This function will send a hang up sequence to both the modem and

the remote panel. If this command is not executed, the panel and computer will never

hang up and the computer will not be able to accept any calls from other panels.

Edit a Batch File

This function is a small editor for the Batch File in the batch program window. Selecting

this function will produce a sub-menu with the following 5 choices:

[I] Insert a line

[D] Delete a line

[C] Clear Batch File

[S] Save Batch File

[E] Erase Batch File

When using these commands, the highlighted line in the Batch File is the one being

modified.

[I] Will insert a blank line before the highlighted line. Then press [ESC] to go

back to the command menu and add the desired command in the blank line.

[D] Will delete the highlighted line.

[C] Will clear the entire file and let you start over again after confirming that is

what you want to do. Press [Y] for “Yes” or [N] for “No”.

[S] Press this key when you are done editing the Batch File, to save it to the hard disk.

[E] Will erase a Batch File from the hard disk, after confirming that you want to

erase it.

To exit this sub menu press [ESC], this will take you back to the command menu.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 109 110

Sin comentarios

Digital Security Controls PC1575 Manual de instalación Pagina 91