Digital Security Controls PC1575 Manual de instalación descargar pdf (Pagina 19)

1.4 Installing the DLS-1 Software

NOTE:

The DLS-1 software is not compatible with Microsoft Windows unless used in

conjunction with the DSC DLS-2 software package. If you are using the Microsoft

Windows for Workgroups v3.11 to install DLS-1 software, 32-bit file access must be

disabled. Do not use a system (boot) disk to install DLS-1. If you have multiple

operating systems and experience problems, make sure that the SHELL command

is set properly. (See your DOS manual.)

The following are step-by-step instructions for installing the DLS-1 software. At any

time you can abort the installation procedure by pressing the [ESC] key. When

prompted, pressing [ENTER] will automatically select the default condition.

The DLS-1 software will require at least 14.6 megabytes of disk space to install. The

procedure is as follows:

1 Insert the diskette labelled “Install Disk” into the proper disk drive.

2 Type the letter of the drive the diskette is in, type a [:], and press [ENTER] (e.g. [A]

[:] [ENTER]).

3 To run the install program, type [DSCINST], then press [ENTER].

4 If you are re-installing this software, or replacing a previous version of the DLS-1

software, pay careful attention to the first question in the installation process. You

will be asked whether or not you want to delete the Work Files. If you say yes, all

of your work files will be deleted. If you are installing DLS-1 for the first time, this

question is irrelevant.

5 Enter the letter designator of the hard disk drive you want to install the DLS-1

software on (e.g. [C]).

6 Enter the name of the directory on the hard drive where you want to install the DLS-

1. This directory must be off of the root directory. If the directory does not already

exist, it will be created for you. Do not install DLS-1 into the same directory that the

installation files are located.

NOTE: Ensure that the directory the DLS-1 software is stored in is not “hidden”. If the

directory or any of the DLS-1 files are “hidden”, the DLS-1 software may not operate

properly. Refer to your operating sytem manual for more information.

NOTE: Do not install the DLS-1 software to the same directory that contains the

DSCINST.EXE, DISK1.EXE, DISK2.EXE AND DISK3.EXE files.

7 You will be asked to verify that the drive letter and directory name are correct. If you

select “No”, you can re-enter this information.

8 If DLS-1 software is already installed in this directory, you will be asked if you wish

to return the settings to the default settings. If “Yes” is selected, all Log On Access

Codes will be erased, the DLS screen colours, and all other configurations will be

restored to the default settings.

9 You will now be asked for four items of information concerning the output ports and

modem to be used on your computer:

• Enter the number of the COM port you want to use for the modem (1 to 4).

• Enter the number of the parallel printer port (LPT) you want to use for the printer

(1 to 3).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 109 110

Comentarios a estos manuales

Sin comentarios

Digital Security Controls PC1575 Manual de instalación Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Digital Security Controls PC1575