Digital Security Controls PC1575 Manual de instalación descargar pdf (Pagina 89)

Store Operations Log to Disk

This selection will erase the current operations log from the computer memory and store

it to either a floppy diskette or to another directory on your hard drive. Depending on the

amount of activity, this function should be done periodically in order to keep your records

organized and make operations log searches faster. A good time period is about once per

month. If you have selected to store onto a floppy disk, you will be prompted to insert a

formatted disk into either Drive A or Drive B. Once you have done this, press [any key] to

begin the storage process. If you have selected to store onto your hard disk, make sure

you enter a directory name that already exists on your hard drive. If you do not, an error

message will result and the directory will NOT be created for you. When the procedure is

complete, a message will indicate success and all Operations Log entries are removed

from your current directory and are now stored on either your floppy disk or hard drive.

The criteria for deciding how much disk space is left on the disk is that each record

takes up 71 bytes, and there must be enough space to store at least 20 records on the

disk. Therefore any disk you wish to use for Storing Operations Log to Disk must have

approximately 1420 bytes free.

It is strongly recommended that you store your floppy disk in a safe location and/or

make a backup of the floppy disk using DOS. THIS IS YOUR ONLY RECORD OF PAST

DLS-1 ACTIVITY.

Review Operations Log From Disk

This function will review Operations Logs previously stored to disk. You can only

review Operations Logs that were saved using the “Store Operations Log to Disk”

function. First select which source you are using. If you have selected Drive A or Drive

B, then insert the correct disk making sure you have removed any write-protect tabs

from the disk. Press [ENTER] to continue. If you have not inserted a disk with the

correct files an error message will result. If the correct files are present, the source disk

will become active for an Operations Log function only. Once you have executed one

view or print function, the current drive will once again become the selected

Operations Log source. To perform another function on the stored Operations Log,

select this function again.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 109 110

Sin comentarios

Digital Security Controls PC1575 Manual de instalación Pagina 89