Digital Security Controls PC1575 Manual de instalación descargar pdf (Pagina 22)

1.5 Running the DLS-1 Software

This section describes how to start the DLS-1 software. For information on DLS-1

menus and functions, refer to sections 2 to 4.

1 At the DOS prompt, type the designator of the drive on which you have installed the

software (C: - Z:), then press [ENTER]. (i.e. [C][:][ENTER])

2 If you are not in the directory where DLS-1 is installed, type [CD\][directory name],

then press [ENTER].

3 Type [DSC] and press [ENTER]. The program will now run. If you want to start DLS

with PC-Link enabled, type [DSCLINK] instead.

4 Upon start up, the system will perform a check routine for a proper

communication link with the modem. If no error message appears, the modem

is connected properly.

If an error message appears indicating that the modem has not been

connected properly, press [ESC] at the prompt to exit the program. Check the

DIP switches on the modem (if using a 1200 baud modem) to see that they are

set properly (refer to Appendix E: Modem Compatibility for information in DIP

switch settings). If an error message still appears, ensure that the modem is

properly installed.

If a modem error message is displayed, but you still wish to proceed, press the

[ENTER] key. If you wish help information, press [Y].

IMPORTANT:

If your modem is not fully compatible, the software may not

work properly.

If you experience problems, refer to Appendix E for more information on

modem compatibility.

If the computer displays an error message describing improper modem connection,

you will not be able to perform any uploading or downloading functions.

If you started the program by typing DSCLINK, no modem check is performed.

5 The LOG ON screen will appear whether or not the modem is connected properly.

Enter either [E] to “Exit to DOS” or [L] to “Log On”. After selecting “L”, a request to

enter an access code will be displayed.

Access Codes may be any combination of up to eight letters or numbers. The initial

access will require the use of the DSC default access code which is [1234]. Press

[ENTER] after typing in this code.

6 The statement “Operator Access Granted” will appear and so will the operator’s name

and/or identifier. Press any key to continue. The Main Menu will now be displayed.

7 If this is the first time you are running the DLS-1 software, you should immediately

do the following.

a) Select ACCESS CODE MAINTENANCE and change the default access code to

your own. You may enter the names of other operators and their access codes and

Status selections at this point. Refer to section 4.7 "Access Code Maintenance" for

more information. Keep a written record of all codes as it will be impossible to enter

the program if they are lost.

b) Return to the Main Menu and select PROGRAM CONFIGURATION. You may now

change the values to suit your own system if this was not done properly during

installation. If the modem port is not configured properly, uploading or downloading

functions cannot be performed. For more information about running the software

and executing Download/Upload functions, refer to Section 2.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 109 110

Comentarios a estos manuales

Sin comentarios

Digital Security Controls PC1575 Manual de instalación Pagina 22

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Digital Security Controls PC1575