Digital Security Controls PC1575 Especificaciones descargar pdf (Pagina 6)

G E T T I N G S T A R T E D

All fire zones must be wired according to the following

diagram:

2.8.5 Fire Zone Wiring – 2-Wire Smoke Detectors

This option is for PC1575 (2-wire smoke option) only. If

PGM2 has been programmed for a 2-wire Smoke Detector

connection

the detectors must be wired according to the

following diagram:

2-wire smoke is only available for PC1575 with the 2-

wire smoke option because it has a 300mA PGM2.

Please refer to Appendix D “PGM Output Options” to

verify whether you have the correct output type.

If a PC1575 (2-wire smoke option) 300mA PGM2 is

programmed for 2-wire smoke support, the connec-

tor CON1 on the main board must be removed.

2.8.6 Keyswitch Zone Wiring (PGM2)

This option is available for either of either a PC1575 (standard

option) or PC1575 (2-wire smoke option). If PGM2 has been

programmed for keyswitch operation (momentary or

maintained) or 24 hour operation, the keyswitches must be

wired according to the following diagram:

2.8.7 LINKS Support

When using the LINKS 1000

cellular communicator, the

connection must be made

according to the accompanying

diagram.

2.8.8 LINKS Supervisory

When using the LINKS 1000

cellular communicator, any

zone may be configured for

LINKS Supervisory.

With a LINKS Supervisory

zone, if the LINKS 1000

experiences a trouble, the

zone will be violated, causing

the panel to report the event to

the central station. This type of

zone

always

requires a single

EOL resistor (5600Ω).

The LINKS Supervisory zone must be wired according to the

accompanying diagram.

2.8.9 LINKS Answer

When using the LINKS 1000

cellular communicator, PGM2

of either a PC1575 (standard

option) or PC1575 (2-wire

smoke option) may be

configured for LINKS Answer

(see Appendix D).(see Appendix D).

(see Appendix D).

A PGM configured for LINKS

Answer allows downloading to

be performed in the event of

phone line failure. When the

LINKS receives a phone call, it will activate the RING

terminal on the LINKS circuit board. The PGM programmed

as LINKS Answer

always

requires a single EOL resistor

(2200Ω).

The LINKS Answer zone must be wired according to the

accompanying diagram.

The LINKS Answer zone is only required for down-

loading to the panel via the LINKS.

If PGM2 is programmed for LINKS Answer, Jumper

CON1 on the main board of a PC1575 (2-wire smoke

option) must be removed. If your PC1575 is the

standard option, then connector CON1 is already

removed (please see Appendix D “PGM Output

Options” for more information).

When using the LINKS, Busy Tone Detection must

not be used.

1 2 3 4 5 6 7 8 9 10 11 ... 42 43

Comentarios a estos manuales

Sin comentarios

Digital Security Controls PC1575 Especificaciones Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Digital Security Controls PC1575