Digital Security Controls PC1575 Especificaciones descargar pdf (Pagina 38)

The following requirements apply to UL Listed systems:

1. All components of the system should be UL listed for the intended

application.

2. If this system is configured for “fire”, the installer should refer to

chapter 2 of NFPA 72 for details in locating smoke detectors and

the typical installation layout shown below.

3. Note that at least one UL listed compatible audible signal

appliance shall be installed indoors.

4. The maximum entry delay times are as follows: Residential - 45s;

Commercial - 60s.

5. The maximum exit delay times are as follows: Residential and

Commercial: 60s.

6. The minimum bell cutoff times are: Residential - 4 min;

Commercial - 15 min.

The installer should advise the user on system operation and

record the source organization name, telephone number, entry

and exit times.

7. Remote programming shall be disabled.

8. The following accessories/modules are not UL listed and shall not

be used with the control unit: PC5400, RS232 serial interface

module, ESCORT5580 voice prompt modules, PC-Link adaptor,

LINKS1000, DLM-1/DLM-4 Downlook modules, PC5004C cabinet.

9. Obvious or common user codes such as 1111 or 1234 should be

avoided.

10. The following programming shall be performed:

A. The delayed 24hr Fire Zone shall not be used.

B. If used, the 24hr heat, 24hr auxiliary, 24hr intrusion

emergency, 24hr sprinkler, 24hr waterflow and 24hr freezer

zones shall be programmed as silent.

C. The Force Arm enable attribute shall be disabled for all zones.

D. The Downlook Activation option shall be disabled for all zones.

E. In commercial burglary applications, the Communications

Enable option shall be selected.

F. In commercial burglary applications, the Closing Confirmation

option shall be enabled.

G. The test transmission cycle shall be 1 day.

H. The Quick Exit feature shall be disabled.

I. The Bypass Status Displayed While Armed feature shall be

disabled.

J. The Swinger Shutdown feature shall be disabled.

K. The Call LINKS as well as Land Line option shall be disabled.

L. The Code Required for Bypassing option shall be enabled.

M. The AC Trouble Displayed feature shall be enabled.

N. The Trouble Light Flashes if AC Fails location shall be

enabled.

O. The Transmission Delay shall not exceed 15s.

P. The Downloading Answer, Call-back and User Initiated Call-

up and Periodic Download features shall be disabled.

Q. For a fire type zone, the bell output shall be passing.

R. For burglary type zones, the bell output shall be steady.

11. The PC1575 shall be used with the following listed receivers and

formats:

Silent Knight Model 9000 - 3/1, 4/1, 4/2 non-extended; 3/1

extended, 10md 20 bps, 1400Hz handshake

Ademco 685 - 3/1, 4/1 and 4/2 non-extended; 3/1 extended,

20bps, 1400Hz handshake. Sescoa super speed and Sescoa

super speed with identified openings/closings.

Lincar Model 3000 - 3/1, 4/1 and 4/2 non-extended; 3/1

extended, 20bps, 1400Hz handshake. Sescoa super speed and

Sescoa super speed with identified openings/closings.

Radionics Model D6500 - 3/1, 4/2 non-extended; 3/1 extended

with and without parity, 1400 and 2300Hz handshake.

Appendix E

U L R E Q U I R E M E N T S

Experience has shown that all hostile fires in family living units generate

smoke to a greater or lesser extent. Experiments using typical fires in

family living units indicate that detectable quantities of smoke precede

detectable levels of heat in most cases. For these reasons, NFPA

standard 72 requires smoke detectors to be installed outside of each

sleeping area and on each additional story of the family unit.

The following information is for general guidance only and it is

recommended that NFPA standard 72 be consulted and that the smoke

detector manufacturer's literature be used for detailed installation

instructions.

It is recommended that additional smoke detectors beyond those required

be installed for increased protection. The added areas include: basement,

bedrooms, dining rooms, furnace room, utility room and hallways not

protected by the required detectors.

Bedroom Bedroom

Basement

Living

Room

Dining

Room

FIG. 3: A smoke detector should be

located on each story of the living unit.

Bedroom Bedroom

Bedroom

Living RoomKitchen

FIG. 1: A smoke

detector should be

located between the

sleeping area and the

rest of the family unit.

Family Room

Bedroom

Living

Room

Dining

Room

Kitchen

Bedroom

FIG. 2: In the family living units with more

than one sleeping area, a smoke detector

should be located to protect each

sleeping area.

FIG. 4: Smoke Detector mounting

- “Dead” Air Space. The smoke

from a fire generally rises to the

ceiling, spreads out across the

ceiling surface and begins to bank

down from the ceiling. The corner

where the ceiling and wall meet is

an air space into which the smoke

may have difficulty penetrating. In

most fires, this “dead” air space

measures about 4 in. (0.1m) along

the ceiling from the corner and

about 4 in. (0.1m) down the wall as

shown in Figure 4. Detectors should

not be placed in the “dead” air

space.

Guidelines for Locating Smoke Detectors

1 2 ... 33 34 35 36 37 38 39 40 41 42 43

Comentarios a estos manuales

Sin comentarios

Digital Security Controls PC1575 Especificaciones Pagina 38

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Digital Security Controls PC1575