Digital Security Controls PC1575 Manual de instrucciones

© 1997 Digital Security Controls Ltd.Printed in Canada 29001851 R2InstructionManualPC1575

The Liquid Crystal Display (LCD) displays prompts andsystem information on two 16 character lines.If “< >” appears, more information can be acce

10Zone BypassingThe zone bypassing function is used when access is needed to part of the protected area while thesystem is armed. Zones which are temp

11Viewing Trouble ConditionsThe control panel continuously monitors a number of possible trouble conditions. If one of these troubleconditions occur,

12To set the system time, enter [✱] [6] followed by the Master Code. Press [1]. The keypad will nowaccept 10 consecutive digits:• Enter the Time in Ho

13From an LED keypad, observe the zone light turn ON when the zone is activated. The zone light willturn OFF when the system restores to normal (i.e.

14AlarmOn a fire alarm, the bell or siren will pulse ON and OFF. The transmission of the alarm to the monitoringstation is delayed for 30 seconds. If

15very important that a family escape plan be developed and rehearsed.1. Every family member should participate in developing the escape plan.2. Study

16Limited WarrantyDigital Security Controls Ltd. warrants that for a period of twelve months from the date of purchase, theproduct shall be free of de

FCC COMPLIANCE STATEMENTCAUTION: Changes or modifications not expressly approved by Digital Security Controls Ltd. could void your authority to use th

© 1997 Digital Security Controls Ltd.Printed in Canada 29001851 R2InstructionManualPC1575

FCC COMPLIANCE STATEMENTCAUTION: Changes or modifications not expressly approved by Digital Security Controls Ltd. could void your authority to use th

1About Your Security SystemYour DSC security equipment has been designed to provide you with the greatest possible flexibilityand convenience. Read th

2System InformationFill out the following information for future reference and store this manual in a safe place.Access CodesYour Master Code is:_____

3Access CodesAccess Codes are used to arm and disarm the system. There are six access codes available: oneMaster Code and five access codes.Only the M

4Alternate Arming MethodsAway ArmingArming the system in the Away mode will have all interior zones and perimeter zones active. If motionis detected i

5Disarming the SystemDisarming from an LED Keypad:Enter the premises through a designated Exit/Entry door; entering by any other door will sound animm

6If An Alarm SoundsFire AlarmIf your system has been installed with fire detectors and the alarm sounds in a pulsing mode, followyour emergency evacua

7Programming codes from an LCD Keypad:Master CodePress the [✱] key to enter the function list. Scroll (< >) to...Press [5] or [✱]. The display w